Difference between revisions of "Yggflexisil"
| Line 2: | Line 2: | ||
<span style="font-size:large;">Links</span> | <span style="font-size:large;">Links</span> | ||
| − | + | <ul> | |
| − | + | <li> [https://github.com/RobotGrrl/Yggflexisil Github repository]</li> | |
| − | + | <li> [https://www.flickr.com/photos/robotgrrl/sets/72157648428418263/ Photoset on flickr]</li> | |
| + | </ul> | ||
<span style="font-size:large;">Setup</span> | <span style="font-size:large;">Setup</span> | ||
Revision as of 07:13, 9 March 2015
Yggflexisil "making of" photos and project video coming soon
Links
Setup
We used NinjaFlex filament for 3d printing the resist onto the Pyralux.
Attaching the Pyralux to a piece of glass helps with the consistency of the print results.
After it is done printing, make sure to check for any 'threads' of NinjaFlex that have to be cut.
Gently cut the thread with an xacto knife. You have to be careful about two things:
1. Lifting the other traces that the thread is connected to
2. Cutting through the backing material on the Pyralux
Taping down the edges of the Pyralux sheet helps with it not curling up when etching.
When etching make sure that it does not go under the resist (too much)
After etching is done and boards are dry, can remove the resist
To remove the resist, just find a corner that can peel off, and then pull it
Now you can remove the board from the glass
Make sure you clean your board (with water) before soldering to it
When soldering to it, have something under the board to absorb some of the heat
Add solder to the places that you do *not* want to flex
That's all!
How it was made
Start out by printing the boards onto a piece of paper, and cutting the Pyralux sheets to size (with some extra border space)
Tape the boards to the back of a 4x6 photo frame piece of glass. Then add glue over it.
Place the Pyralux onto the glue (copper side up), make sure that there is no bubbles. Tape down the edges of the board.
Place the slide onto the printer bed. Tape it down just in case.
Level the platform, it will take a bit of trial and error
Lots of trial and error
What the boards look like with the resist on them
Scratch away the tiny 'hairs' from the filament that may bridge traces
Boards after chemically etching
They look really pretty with the light
Remove the boards from the glass, and also remove the resist
Cut out the boards
Begin soldering
Test run
3D print the stand
Don't forget to add a cheesy saying!
Attach board onto the stand
Done!
